Setup Guide

Table 8. Peripheral Settings for wnos.ini Files, {username} INI, and $MAC INI files (continued)
MouseDisable — Default is no. Yes/no option to disabled
mouse pointer so that it is shown on the screen. The pointer is
enabled if any mouse activity occurs.
LpdSpool={0-50} Specifies the size of spool to buffer all the data before
sending them to the LPD printer. The range of value is 0 to
10, that is, 0 MB to 10 MB. If the specified value is above the
range, then the value is set to 5.
The range of value is extended to 50.
In build 8.2_001 or later builds, the LPD data is spooled to
a file in a ram disk instead of a buffer. So the value of the
parameter will not be related to the spool size as before.
If LpdSpool=0, the function is disabled, otherwise the function
is enabled.
LPTPortBind={yes, no}
LPTPortBind — Default is Yes. Specifies the LPT bind to the
USB Port Policy.
If set to Yes, then the registered port follows the following
binding policy: LPT1 from USB ports 1/3/5/7 and LPT2 from
USB posts 2/4/6.
If set to No, then the LPT port plugged in first is LPT1
followed by LPT2, and so on.
MicBoost={no, yes}
Default is no.
Yes/no option to enable on-board microphone boost.
**MouseNewSpeed={1-9}
Default is 6.
Value specifies the mouse speed within a range of 1 through
9, where 1 is slowest and 9 is fastest. This parameter is the
replacement of MouseSpeed from build 7.0.1_07.
**MouseSwap={0, 1}
0/1 option to swap the mouse buttons. For example, for left-
handed use.
0 — No
1 — Yes
NetworkPrinter=host/queue
[PrinterID=Window driver name]
[Enabled={no,
yes}]
NetworkPrinter — Specifies the configuration for the
network (LPD) printer in the same way as described for
the Printer Setup dialog box in the Dell Wyse ThinOS
Administrator’s Guide. The host and queue parameters define
the IP address and queue name of the printer.
PrinterID — Specifies the Windows printer driver name.
Enabled — Default is yes. Yes/no option to enable the
network (LPD) printer.
Printer={COM1, COM2, LPT1, LPT2}
[Name=<name>]
[PrinterID=window_driver]
[Class=classname]
[Enabled={no,
yes}]
[EnableLPD={no, yes}]
Default is COM1.
Printer — Specifies the local printer to configure.
Name — Specifies the name of the printer. This option
must be used.
PrinterID — If not specified, the default Generic/Text Only is
used.
Class — Used in ThinPrint print for TPAutoconnect; the
ThinPrint technology of mapping the printer from the client
side. It can group printers to use the same template on the
Parameters for wnos INI, {username} INI, and $MAC INI files 63