Setup Guide

Table 5. Connection Settings: wnos.ini files only (continued)
Parameter Description
NOTE: Use our Windows Password_Gen tool or built-in tool to generate
the encrypted string.
ConnectionBroker={default, VMware,
Microsoft, Quest, AWS}
[IgnoreProfile={yes, no,}]
[SecurityMode={Default,Low,Warning,Full}]
[EnableVWGateway]={yes, no}
[VWGateway]=url
[ConnectionType]={Default, All, RDP, PCoIP,
Blast}
[EnableVDMCredSSP]={yes,
no}
[RDCollections={*collect1, collect2,...}]
[DisableShowDisclaimer=[yes,
no]
[DisableShowServer=[yes,
no]
[EnableUnauthenticatedAccess]={yes,no}
[Host={broker_url}]
[AutoConnectList={*|host1;host2;host3...}]
[VMWaitTimer={0–3600}]
[UseRegistrationCode={yes, no}]
[EnableAWSREGCode={yes,no}]
[EnableMFA={yes, no}]
Default value is default. Specifies the type of VDI broker to use. Default is a
3rd party VDI broker.
AWS is Amazon Workspace broker. It is only available with PCoIP build.
IgnoreProfile — Default value is no.
Set IgnoreProfile=yes to disable parsing the global setting from the VDI
broker. It is only valid in the case of ConnectionBroker=default.
SecurityMode — SecurityMode specifies the security mode for the VMware
broker and Amazon Workspace (AWS) broker. It is only valid in case of
ConnectionBroker=VMware or ConnectionBroker=AWS. The details is as
follows:
● Set SecurityMode=Full to have the Client verify the server's certificate in
highest security mode; if any relevant checks error, it will fail to connect
to the server.
● Set SecurityMode=Warning to have the Client allow connection
continuation in the following two specific exceptions where full
verification would fail:
1. Certificate is self-signed.
2. Certificate has an invalid time.
● Set SecurityMode=Low to indicate that Client allows connection without
any certificate verification.
● Set SecurityMode=Default to indicate that Client follows the
SecurityPolicy setting to verify the certificate.
NOTE:
For Dell vWorkspace broker, ConnectionBroker=Quest is recommended.
EnableVWGateway and VWGateway are used to set the vWorkspace
gateway.
For VMware broker, ConnectionBroker=VMware is recommended.
ConnectionBroker=VDM is still supported but deprecated.
The option ConnectionType specifies the display protocol that you want to
use when launching a session in VMware broker. If this parameter is set, then
the desktops that meet the specified protocol are listed after broker sign on.
This setting is only valid in case of PCoIP feature is supported.
● Set ConnectionType=Default, only the desktops with the default protocol
configured in broker server are listed (this is the default value for this
setting).
● If you set ConnectionType=All, both PCoIP and RDP desktops are listed.
● If you set ConnectionType=RDP, only RDP desktops are listed.
● If you set ConnectionType=PCoIP, only PCoIP desktops are listed.
● If you set ConnectionType=Blast, only Blast desktops are listed.
EnableVDMCredSSP=yes—The option is set to yes to enable RDP NLA
mode connection when the VMware View broker session is launched. The
default value is no. EnableVDMCredSSP=yes works only after you disable
view security tunnel in server side.
20
Parameters for wnos INI files only