Administrator Guide
Table Of Contents
- Dell Wyse ThinOS Lite Release 2.6 Administrator’s Guide
- Introduction
- Before working on ThinOS Lite
- Getting started
- Global connection settings
- Configuring the connectivity
- Configuring the network settings
- Configuring the remote connections
- Configuring the Citrix broker setup
- Configuring the visual settings
- Configuring the general options
- Configuring the authentication settings
- Configuring the central configurations
- Configuring the VPN manager
- Configuring the connection broker
- Configuring Citrix
- Configuring the Citrix broker setup
- Citrix HDX RealTime Multimedia Engine—RTME
- Citrix Icon refresh
- Using multiple audio in Citrix session
- Using Citrix NetScaler with CensorNet MFA authentication
- Okta Integration through Citrix NetScaler
- Configuring ICA connections
- ICA Self Service Password Reset—SSPR
- QUMU or ICA Multimedia URL Redirection
- HTML5 Video Redirection
- ICA SuperCodec
- Anonymous logon
- Configuring the Citrix UPD Printer
- Introduction to Flash Redirection
- Configuring Citrix
- Configuring Zero Client Settings
- Performing Diagnostics
- BIOS Management
- Security Changes
- Creating and Using xen.ini Files
- Examples of Common Printing Configurations
- Important Notes
- Troubleshooting
The zero client checks for a wired network connection. If the network connection is successful, a welcome screen with the
model name of your zero client is displayed.
The zero client validates the IP address from DHCP. If the DHCP contains the file server or Wyse Device Manager or Wyse
Management Suite configurations, then the ThinOS Lite system desktop is loaded without entering First Boot Wizard. If the
DHCP validation fails or if you have not connected to Ethernet, then follow the next step.
NOTE: To exit First Boot Wizard during the network connection status check on the welcome screen, press the Ctrl +
Esc key.
3. On the Would you like to load a ThinOS Lite configuration file from USB? screen, do either of the following:
Figure 3. USB configuration
● To load a ThinOS Lite configuration file from the USB drive, ensure that you create a xen.ini file and add the file to
the /xen directory on the USB drive. Plug the USB drive to zero client, and click Yes.
NOTE:
Only FAT, FAT32, and ExFAT file systems on the USB disk are supported. NTFS file system is not supported.
The zero client validates the configuration file in the USB drive.
○ If the ThinOS Lite configuration file in the USB drive is correct, the Read configuration success message is
displayed. Click OK to exit First Boot Wizard, and log in to ThinOS Lite system desktop.
○ If the ThinOS Lite configuration file in the USB drive is corrupted or the required file is not available, then the Can
not find configuration files, or read configuration failure message is displayed. Upload the correct file on the
USB drive, plug the USB drive again, and then click Retry. If the file is correct, the Read configuration success
message is displayed. Click OK to exit First Boot Wizard, and log in to ThinOS Lite system desktop.
If you do not want to use the Retry option to load the ThinOS Lite configuration file, then click Abort to enter the
System Preferences configuration setup.
NOTE:
To exit the Can not find configuration files, or read configuration failure message screen, and load
the ThinOS Lite system desktop, click Exit.
● To enter the System Preferences configuration setup, click No.
4. On the System Preferences Configuration screen, configure the following options:
16
Getting started