Administrator Guide

Table 22. Parameters for a xen.ini File (continued)
Parameter Description
AddCertificate=client cert.pfx
password=passpass
The Caradigm Vault server uses the certificate to validate the
connection between the Tap Server and the zero client. Use this
INI parameter certificate to Zero Client.
AdminMode={yes, no}
[admin-username=<encrypted_username>]
[admin-password=<encrypted_password>]
[Username=<username>]
[Password=<password>]
[ShowAdmin]={yes, no}
[Enc-username=encrypted_username]
[Enc-password=encrypted_password]
[ShowAESButton={yes, no}]
Default is no.
AdminMode — Yes/no option to use the username and the
password to obtain a high privilege zero client configuration when
the Privilege parameter level is set to high (Privilege=high).
admin-username — Specifies if admin-
username=encrypted_username, then encrypted strings are used
for admin-username, no minimum length; maximum length is 30
characters—15 characters convert to 30 characters encrypted.
admin-password — Specifies if admin-
password=encrypted_password, then encrypted strings are used
for admin-password, no minimum length; maximum length is 30
characters—15 characters convert to 30 characters encrypted.
Enc-username — Specifies if the username is encrypted, and
encrypted strings are used for the Enc-username.
Enc-password — Specifies if the password is encrypted, and
encrypted strings are used for the Enc-password.
NOTE:
● Enc-password — Specifies if the password is encrypted,
and encrypted strings are used for the Enc-password.
● password — Specifies the password, no minimum length;
maximum length is 15 characters.
ShowAESButton=yes—In this option AES Encrypt button
populates in System Admin, when user enters the administrator
mode. Click AES Encrypt to launch encrypted generator to
generate enc-password for INI settings. You can hide AES Encrypt
if ShowAESButton=no. If Enc-Username and Enc-Password is
presented, the default value is yes. Otherwise, the default value
is no.
AutoLoad=[0, 1, 2, 101, 102, 201, 202]
[LoadPkg={0, 1, 2}]
[AddPkg={pkg1_name, pkg2_name, …}]
[DelPkg={pkg1_name, pkg2_name, …}]
[VerifySignature={yes,no}]
[UpgradeOrder=(bios,wtos)]
Default is 1.
Specifies the firmware update mode.
0 — Disable checking for image.
1 — (Default) Enable a forced firmware upgrade/downgrade
process.
2 — Enable a comparison/non-forced upgrade only process.
101 — Enable firmware upgrade/downgrade process, but have
a popup message that identifies the firmware version, and then
prompts with OK and Cancel buttons appearing before the process;
completion message appears after process.
102 — Enable upgrade only, but have a popup message that
identifies the firmware version, and then prompts with OK and
Cancel buttons appearing before the process; completion message
appears after process.
201 — Enable a forced firmware upgrade/downgrade process, but
have a popup message with OK button appearing before process
although process will begin in 20 seconds in any case; completion
message appears after process.
166 Creating and Using xen.ini Files