Administrator Guide
Table Of Contents
- Dell Wyse ThinOS Lite Release 2.6 Administrator’s Guide
- Introduction
- Before working on ThinOS Lite
- Getting started
- Global connection settings
- Configuring the connectivity
- Configuring the network settings
- Configuring the remote connections
- Configuring the Citrix broker setup
- Configuring the visual settings
- Configuring the general options
- Configuring the authentication settings
- Configuring the central configurations
- Configuring the VPN manager
- Configuring the connection broker
- Configuring Citrix
- Configuring the Citrix broker setup
- Citrix HDX RealTime Multimedia Engine—RTME
- Citrix Icon refresh
- Using multiple audio in Citrix session
- Using Citrix NetScaler with CensorNet MFA authentication
- Okta Integration through Citrix NetScaler
- Configuring ICA connections
- ICA Self Service Password Reset—SSPR
- QUMU or ICA Multimedia URL Redirection
- HTML5 Video Redirection
- ICA SuperCodec
- Anonymous logon
- Configuring the Citrix UPD Printer
- Introduction to Flash Redirection
- Configuring Citrix
- Configuring Zero Client Settings
- Performing Diagnostics
- BIOS Management
- Security Changes
- Creating and Using xen.ini Files
- Examples of Common Printing Configurations
- Important Notes
- Troubleshooting
Troubleshooting
● ThinOS Lite devices allow secure SSL connections—SecurityMode=Full—only after verifying the certificates. In the
present scenario, the devices enforce the warning policy after you define a server using a valid IP address. The resolution for
the issue will be delivered in the next ThinOS Lite release.
The following are the workarounds to avoid the SSL connection issue:
○ Ensure that the device has a valid certificate and the correct time is selected on the device.
○ Define the server by name instead of IP address.
○ Set the value of the global security policy to high.
○ Use the following INI parameter to enforce the high security mode:
SecurityPolicy=high TLSCheckCN=Yes
● Firmware/Package update—When the packages fail to update or cannot function (cannot connect desktop) after update
with new version firmware; if there is further failure, a work around would be to remove all packages and re-install all of
them on reboot.
● Boot up unit without monitor or with monitor power off.
○ If the thin client waits for 15 to 20 seconds and the monitor is attached or powered on within 20 seconds, the display is
turned on. If the monitor is attached or powered on after 20 seconds, the monitor displays the black screen. Turn on the
monitor first, and then turn on the thin client.
D
Troubleshooting 235