Administrator Guide

3. Click OK to save the settings.
Configuring the display settings
Use the Display dialog box to select the resolution and refresh rate for the monitor used with the thin client.
Configuring the display setup
This section is applicable to Wyse 5070, Wyse 5470, and Wyse 5470 All-in-One thin client. Use the Display Setup dialog box to
configure the display settings for the connected monitors.
To configure the display setup:
NOTE: On Wyse 5470 Thin Client, the built-in display stays on by default.
1. From the desktop menu, click System Setup, and then click Display.
The Display Setup dialog box is displayed.
2. In the Display Setup dialog box, configure the following options:
● Mirror mode—Select the Mirror mode check box to enable all connected monitors to use the same display settings
configured on the primary monitor.
The following screen represents the Mirror mode configuration.
158 Configuring local settings