Reference Guide

Option Description
Host=[name, IP, $SYS VAR]
Host — A list of server host names or IP addresses to which the
thin client will attempt to connect; the next server on the list is
attempted if the previous one failed. List items must be separated
by semicolons or commas.
NOTE:
$UN species that the sign-on user name is used and should
be set in a {username}.ini le. , see System Variables. If set to
Host=$UN in a {username}.ini le, the hostname will display
as the sign-on user name. If set to Host=$UN in a wnos.ini
le, the hostname will display as the default Start.
Icon={default, bitmap le}
Species an icon to appear on the thin client desktop for a
connection. Use Icon=default to display a system default icon for a
connection.
To use an icon other than the default icon, enter the name with
extension of the bitmap le; ensure that the le is located in the
FTP server wnos\bitmap directory. If Icon= is not specied and the
icon is not specied by a PNAgent/PNLite server, no icon is
displayed for a connection.
KeepAlive={0 to 127}
Default is 10.
Species the number of minutes to keep a session connected after
the session is inactive. During this period, one dummy packet will be
sent to the server if network trac is lost.
LocalCopy={no, yes}
Default is no.
Yes/no option to save the connection to the local NVRAM.
The connection description of the Description option is used as the
index key into the local connection table. If a match is found, then
the entry is updated. Otherwise, a new entry is created.
Maximum total of local entries is 16.
Logon_mode=prompt
Species one dialog box will pop up to allow a user to enter
username, password, and domain before connecting to the RDP
session. This can prevent the need to input credentials twice in
some cases of server redirection (load balancing).
Lowband={no, yes}
Default is no.
Yes/no option to enable optimization for low speed connections
such as reducing audio quality and/or decreasing protocol-specic
cache size.
Mapdisks={no, yes}
Default is no.
Yes/no option to auto-connect and map any connected USB ash
drive upon connection start.
NoReducer={no, yes}
Default is no — Enables compression.
Yes/no option to turn o compression. To turn o compression,
enter yes. Used here is an option of the Connect statement. It sets
the value of NoReducer only for this specied connection.
104 Connect Parameter: Options