Reference Guide

Parameter Description
[servers=server_list] communityReadOnly— This option is to set community only has
snmp get and get_next privileges. The following encrypt option is
only for indicating, if value of communityReadOnly is encrypted.
Servers —This option is set to limit the valid snmp management
site to the IP addresses in the server_list parameter, which contains
1 to 4 IPv4 IP addresses currently. If not, all the set IP addresses
seen as valid.
Service=thinprint disable={no, yes}
[port=<port number>]
[PkSize={0-64000}]
Default is no.
Service=thinprint disable — Yes/no option to disable the thinprint
service.
port — Same as the statement ThinPrintEnable={no, yes}
port=portnumber.
PkSize — Species the default packet size that will be sent to the
server when negotiating with the thinprint server. The value 0 will
rely on the server default setting, 64000 in ThinPrint 7.6 and 32000
in previous ThinPrint versions.
ThinOS only allocates a buer of 64K, so if the default packet size
of the server is above 64000, this setting must be set or printing
will fail.
Service=vncd disable={no, yes}
[servers=server_list]
[HttpPort=_http_port_]
[TcpPort=_tcp_port_]
Service=vncd disable—Yes/no option to disable the vncd service,
same as MaxVncd={0, 1}.
Default is no.
servers—Use the servers option to limit the valid vncd client site
to the IP addresses in the server_list parameter, which contains
IPv4 IP or IP range addresses, such as 192.168.1.0/24; 192.168.2.48.
If this option is not set, all IP addresses are displayed as valid.
The service vncd supports both http and tcp connections. The
option HttpPort enables you to set the http port for vncd service.
The default port is 5800.
The option TcpPort enables you to set the tcp port for vncd
service. The default port is 5900.
Service=wdm disable={no, yes}
Default is no.
Yes/no option to disable the WDM service, same as
RapportDisable={no, yes}.
Service=<port number> disable={no, yes}
Default is no.
Yes/no option to disable the service with this port number. The 80
port is an exception because the WDM is always started before
loading the global prole (wnos.ini le).
SecurityPolicy={full, warning, low}
[SecuredNetworkProtocol={yes, no}]
[TLSMinVersion]={1,2,3}]
[TLSMaxVesion={1,2,3}]
Species the global security mode for SSL connection. If
application SecurityMode is default, application applies the setting.
If set to full, the SSL connection needs to verify server certicate.
If it is untrusted, connection is dropped.If set to warning, the SSL
connection needs to verify server certicate. If it is untrusted, it is
up to you to continue or drop the connection. If set to low, the
server certicate is not checked.
Parameters for wnos INI les only 35