Reference Guide

Parameter Description
Whenever a reboot is required from Wyse Management Suite
agent, a warning dialog window is displayed. The user can postpone
the reboot for as many times set by the admin.
WDMFlash=ash_size
The specied value will be saved into NVRAM, and then reports to
the WDM server. This statement ensures that all the units would
function with DDC regardless of ash size.
This statement is valid for all platforms and replaces the previous
S10 WDM Flash statement.
WDMService={yes, no}
[DHCPinform={no, yes}]
[DNSLookup={no, yes}]
[QuickMode={yes, no}]
[Discover={yes, no}]
[SecurityMode={default, full, warning, low}]
Default is yes.
WDMService — Yes/no option to disable the WDM agent.
Discovering the WDM server is supported by the following:
1 DNS host name lookup wdmserver
2 DNS service location record _wdmserver._tcp
3 DHCP option tag values received from standard or WDM
proxy DHCP service for vendor class RTIAgent
DHCPinform — Default is no. Yes/no option to use DHCP
information.
DNSLookup — Default is no. Yes/no option to use DNSLookup.
For Example: If WDMService=yes, setting DHCPinform=yes will do
number 3, setting DNSLookup=yes will do numbers 1 and 2.
If QuickMode=yes is specied, rapport agent will not block any
other process during ThinOS boot up, and boot time of ThinOS will
speed up.
NOTE: If le server is changed by WDM server, device will
reboot automatically to make sure all settings from WDM
server take eect. Default is yes.
Discover— If Discover=yes is specied, rapport discovers the
WDM server information from the DHCP option tag, DNS service
location record and DNS host name. If the WDM server is
discovered, the WDM server User Interface (UI) is protected on
device. The default value is yes.
SecurityMode species the SSL certication validation policy.
If set to default, it will apply SecurityPolicy setting.
If set to full, the SSL connection needs to verify server certicate.
If it is untrusted, then drop the connection.
If set to warning, the SSL connection needs to verify server
certicate. If it is untrusted, it's up to you to continue or drop the
connection.
If set to low, the server certicate is not checked. The value is
persistent, and the default value of the setting is default. If the
settings are factory default, or if you are upgrading to ThinOS 8.3
for the rst time, the value is temporarily set to low. After loading
any INI, it goes to default value.
WDMServer=<server_list>
WDMServer — Species a list of IP addresses or DNS names
separated by using a comma for the WDM servers. Once specied,
it is saved in non-volatile memory.
42 Parameters for wnos INI les only