Administrator Guide
Table Of Contents
- Dell Wyse ThinLinux 1.0.3 INI Guide
- Introduction
- Getting Started: Learning INI File Basics
- General Settings Parameter Options
- Peripheral Settings Parameter Options
- Connection Settings Parameter Options
- Custom GNOME Settings Parameter Options
- Connect Parameter Options
- Printer Parameters Option
- TimeZone Parameter: Values
- Keyboard.layouts Parameter: Values
Parameter Description
rotate-left, rotate-normal, and rotate-right are supported as legacy
parameters. These parameters rotate the framebuer for monitors
that do not actually support rotation. Specifying these parameters
requires monitors to be physically rotated. For monitors that support
rotation, these parameters are not necessary.
<default>
This key value is to reset both monitors to default settings. (Optimal
resolutions in horizontal placement and MON1 on the left as primary
display).
DDC
Resets all the monitors to default layout and default resolutions – The
default layout is all in HORIZONTAL placement, Primary is MON1
and resolutions are optimal.
Horizontal
For Example: DisplaySettings=Horizontal (which is equal to
DisplaySettings= <default>) OR DisplaySettings=Horizontal MON1
primary 1920x1080 MON2 1920x1200
This single Horizontal (with capital H) key value without any
parameter is used to reset both the monitors to DDC mode as it is in
default settings. There can be parameters as in MON1 and MON2
format as described above. The result is to set the monitors in
horizontal placements with specied individual parameters.
Vertical
For Example: DisplaySettings=Vertical (which is equal to
DisplaySettings= <default>) OR DisplaySettings=Vertical MON1
primary 1920x1080 MON2 1920x1200
This single Vertical (with capital V) key value is used to set both
monitors to DDC resolutions, but in vertical placement with default
MON1 on the top.
MON2 … MON1…
With individual monitor with their specic parameters in place, but
swaps the MON2 at the beginning of the string, followed by MON1
will be placed MON2 on the left and MON1 on the right. This is
equivalent of MON1 on-right MON2 on-left. For Example: MON2
MON1 = MON1 on-right MON2 on-left
Mirror <rotate{normal, left, right, inverted}, {resolution}>
It sets the monitors in mirror mode with given resolution and rotation.
JetDirectPrinter=<printer address>
For Example: JetDirectPrinter=<printer address> <options>
For parameter options used in the command line, see
JetDirectPrinter in Printer Parameters Options.
Mouse.MouseSpeed={value 0 to 6 and <default>} It Species the speed when you are moving the mouse.
0 – Slowest
6 – Fastest
19