Release Notes

Smart Card info from ThinOS
event log
Driver Provider (CSP) Card type
SafeNet High Assurance Applets SHAC v2.12.020 SafeNet Smart Card Key
Storage Provider
SafeNet SC650 v4.1
Known issues
This section describes the known issues in this release.
Table 45. Known issues
Issue number Issues description Workaround
TL-923,
BITS364686
A black or ickering screen is observed when you connect
a 4K monitor to DP1 port on Wyse 5070 thin client with
Intel Dual Band Wireless AC 9560 chipset.
This issue is applicable to 8.5_107 build.
Congure the display resolution to less than 4K resolution
on monitor connected to DP1 port. This is specic to DP1
port and independent of the devices connected to other
ports.
TIR94834 After reboot, you cannot reconnect the Bluetooth
headsets, and you must reboot headsets to reconnect.
This functionality works as designed by Intel.
This issue is applicable to 8.5_107 and 8.5_108 build.
Reopen the Bluetooth headset to reconnect.
TIR95564 After restoring the thin client to factory default settings,
the Bluetooth connection may fail when you connect to a
Bluetooth device the rst time. However, the thin client
connects to the Bluetooth device from second instance
onwards.
This issue is applicable to 8.5_107 and 8.5_108 build.
There is no workaround.
TIR96240 When you initialize the bluetooth, the screen ickers black
only once before you disconnect the client from its power
source and then turning on the client again (power
cycling).
This issue is applicable to 8.5_108 build.
This issue will be xed in next release.
TIR95172
If you enable IPv6 for both ENET0 and ENET1, IPv6
routes through the Ethernet connection that fetches the
IPv6 address rst.
There is no workaround.
TIR95414 Hot plugging a monitor may result in a black screen in the
VDI connected session. You must recover monitor to
recover the session screen. The issue will be resolved in
the next release.
Power o and power on the monitor, or remove the video
cable from the client and connect the video cable to the
port again.
TIR95681 Hot plugging a monitor during VDI connection or Display
setup conguration may result in unexpected issues, such
as terminal freeze or display layout change.
The issue will be resolved in the next release.
TIR95083 In Mirror mode with active session, change the resolution
from 2048 x 1280 to greater than 2048 x 1280. The
connected RDP session (Windows 8/ Windows 2012 R2)
is closed forcibly and an error message—RDP: The
server-side graphics subsystem is in an error state and
unable to continue graphics encoding is displayed. This is
because the session is not reconnected in Mirror mode
after resolution is changed that resulted in H.264 codec
exceeding its supported resolution.
You must manually reconnect the session after the
resolution is changed.
58 ThinOS 8.5_107