Setup Guide
Table Of Contents
- Dell Wyse ThinOS Version 8.5 INI Reference Guide
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for wnos INI files only
- Parameters for wnos INI, {username} INI, and $MAC INI files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Table 8. Peripheral Settings for wnos.ini Files, {username} INI, and $MAC INI files (continued)
[width={camera supported width}]
[height={camera supported height}]
[fps={camera supported fps}]
[samplerate={0, 1, 2, 3, 4, 5}]
[optimize={
no, yes}]
[Disable={yes, no}]
format — Support only for raw video type; format=raw is
fixed.
width — The width of the resolution that the local camera
supports.
height — The height of the resolution that the local camera
supports.
fps — The frame per second (fps) of the resolution that the
local camera supports.
samplerate — The software level sample rate based on fps
to optimize the performance, where the frame per second
for the camera is actually equal to the fps value multiplied by
the samplerate value. Samplerate values mean the following
sample rates:
0 — 1/1
1 — 1/2
2 — 1/3
3 — 1/4
4 — 1/5
5 — 1/6
optimize — Default is no. Yes/ no option to optimize the
width, height, and fps at 320 x 240 at 10 fps. That is, if
optimize=yes, then 320 x 240 at 10 fps will be used for the
local camera settings regardless of the individual settings in
width, height, and fps; as long as the camera supports the 320
x 240 at 10 fps.
If optimize=yes and the camera does not support the 320 x
240 at 10 fps settings, an error will be present in the Event
Log of ThinOS.
If optimize=no then the individual settings in width, height,
and fps will be used as long as the camera supports them.
Disable— When you specify Disable=yes, the device is
disabled. For example, the Camera tab in peripherals setting
is disabled, the Exclude video devices option in Global
Connection Settings is disabled. The device cannot be
accessed at local and remote sessions.
**Device=keyboard
[numlockoff={no, yes}]
[repeatrate={0,
1, 2}]
[repeatdelay={0, 1, 2, 3, 4, 5, 6, 7}]
Device — Specifies the local keyboard.
numlockoff — Default is no. Yes/no option to turn off the
NumLock of the keyboard.
repeatrate — Default is 1. Specifies the keyboard repeat
rate.
0 — Slow
1 — Medium
2 — Fast
repeatdelay — Default is 2. Specifies the keyboard delay in
seconds, before repeat.
0 — 1/5
1 — 1/4
2 — 1/3
3 — 1/2
Parameters for wnos INI, {username} INI, and $MAC INI files 61