Release Notes

Table 105. INI parameters (continued)
INI parameters Description*
[trace=NetiD driver log path and
name]
The trace parameter enables you to set the driver log path and file name.
For example, trace=/tmp/secmaker.log.
[SCHidePINLeft={yes, no}]
The SCHidePINLeft parameter enables you to hide or display the number
of attempts remaining to enter a correct PIN for the smart card. The default
value is no.
[PowerSaveControl={0, 1}]
[RSSIAmend={}]
The PowerSaveControl parameter enables or disables power saving for
Intel wireless chips. The default value is 0. This parameter is applicable to
Wyse 5060 thin client. When you enable the wireless powersave feature on
the Wyse 5060 thin client, the wireless stops functioning occasionally. To
resolve this issue, disable the powersave feature using the PowerSaveControl
parameter.
The RSSIAmend parameter enables you to manually modify the value of
wireless RSSI. This parameter is applicable to Wyse 5070 thin client.
RSSIAmend=5 means that the signal level is increased, and RSSIAmend=-5
means that the signal level is decreased.
SmbVersionRange={version_range}
The SmbVersionRange parameter controls the SMB protocol version that
is used in SMB printer communication. The client only uses the SMB version
that is specified in version_range.
The format of version_range is lowest_version,
highest_version. LM2 stands for LAN manager 2, SMB1 for SMB version
1, and SMB2 for SMB version 2. For example,
SmbVersionRange=SMB2,SMB2 means only SMB version 2 is allowed;
SmbVersionRange=,SMB2 means SMB version 2 and all the supported
lower versions can be used. Default version range is set by
SmbVersionRange=,SMB1. By default, SMB2 is not supported.
*For detailed descriptions, see the Dell Wyse ThinOS Version 8.6 INI Reference Guide at www.dell.com/support.
160
ThinOS 8.6_019 and ThinOS Lite 2.6_019