Setup Guide

NOTE:
Slide the hex nut across the stand surface so that it easily slips into the recessed cut-out in the horizontal stand.
Use the plastic bracket with the hex holes.
2 Removing the monitor stand
a Place the monitor panel face down on a soft cloth or cushion.
b Remove the stand from the monitor by pushing the monitor’s quick release button as indicated in the following illustration.
3 Attaching P-series mount to the monitor
a Remove the monitor screws from the back of the monitor and use them when you proceed with installation later.
b Position the P-series mount on the back of the monitor. Tilt and slide the top tabs into the dedicated tab slots, and then rmly
slide down bottom edge of mount until it snaps in place.
c Reinstall the monitor screws.
12
Mounting Wyse 3010, Wyse 3020, Wyse 3030, Wyse 3030LT, and Wyse 5030 clients