Install Guide

10 Chapter 4
4. Place your thumbs on the top surface above where the end screws were removed.
With a continuous motion, push firmly downward and towards the back panel (pushing
down unlatches the hooks under the cover). The cover will shift approximate 1/4 inch to
hang over the back panel, as shown in Figure 9.
Figure 9 Unlatching the cover
5. (a) Grasp the overhanging cover edge and raise the edge
about 1-1/2 inches, and then (b) pull the cover out towards the back panel at the same
angle to free the opposite end of the cover from the remaining hooks, as shown in
Figure 10.
Figure 10 Removing the cover
6. Remove the cover to expose the flash module, as shown in Figure 11.
7. Remove the existing flash module. Locate the flash module and use the Phillips
Screwdriver to remove its retaining screw as shown in Figure 11. Lift the flash module
out of the socket.