Install Guide

Installing Z Class Flash 11
Figure 11 Removing the existing flash module
8. Install the new flash module in the reverse order of removing the original flash module.
Carefully screw down its retaining screw until it is secure.
WARNING: Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD. Before you
remove or install a module, touch any metal part of the chassis and keep that contact
with the chassis during the installation process.
9. (a) Align the cover screw tabs with screw holes and press downward; (b) slide cover
toward the front of the thin client, as shown in Figure 12.
Figure 12 Reattaching the cover
10., Attach the screws in the reverse order as described in step 3.
11.Connect the power cord and power adapter, attach any other cables to the thin client,
and then attach the vertical foot.
CAUTION: Do not turn on the thin client. The thin client is ready to re-image, however
the flash module does not contain an operating system. Turning on power to your thin
client without firmware will display the error message “NO OPERATING SYSTEM
FOUND.”
What’s Next
Continue with "Installing Firmware."