Setup Guide

Table 7. General Settings: wnos.ini files, {username} INI, and $MAC INI Files (continued)
[VideoSpan=no]
[Unit=hour]
[Image=imagefile]
[PictureTimer={2-60}]
[PictureOrder=random]
[PictureCheck=always]
[PictureLayout={
stretch, tile, center}]
[Sleep={0-180}]
3- 3 Minutes
5 — 5 Minutes
10 — 10 Minutes
15 — 15 Minutes
30 — 30 Minutes
The default screen saver value is 10 minutes and the maximization value is 30
minutes.
LockTerminal— This is an optional parameter and specifies to put the thin
client in LOCK state when the screen saver is activated. Default is 0.
0 — Disabled.
1 — Puts the thin client in a LOCK state when the screen saver is activated.
The wallpaper is shown and the user is prompted with an unlock dialog box to
enter the sign-on password to unlock the thin client. LockTerminal settings
are saved into NVRAM if LockTerminal=1and EnableLocal=yes is set in the
wnos.ini file.
2— Puts the thin client in a LOCK state when the screen saver is activated,
however, the wall paper cannot be viewed when the user is prompted with an
unlock dialog box to enter the sign-on password to unlock the thin client.
3— Puts the thin client in a LOCK state when the screen saver is activated,
and the username and password are needed to unlock the terminal. The
wallpaper is not shown and the Password field in the Unlocking window is
invisible until you have entered the username.
When you click OK or press the Return key, a message box pops up to input the
username and password to unlock the terminal.
NOTE:
The user must be signed on with a password for a Lock action to take
effect. If set in KeySequence, users can lock the thin client at any time by
pressing Ctrl+Alt+Left arrow or Ctrl+Alt+Right arrow.
Unit — This parameter converts the screen saver timer value from minutes to
hours to set longer time.
Type — Specifies which type of screensaver to use.
0 — Blank the Screen
1 — Flying Bubbles
2 — Moving Image
3 — Showing Pictures
4 — Playing Video
VideoLink — Specifies the video link address of the video file. Links with only
http are supported. The mp4 video format is supported.
VideoSpan — Specifies the video displayed mode in the screen. If the dual
head is in span mode and VideoSpan=yes, it is spanned across all the screens. If
VideoSpan=no, it is displayed in the main screen.
Imagefile — This is an optional parameter and specifies an image file residing
in the bitmap sub-folder under the home folder to be used as a Moving Image
screensaver.
If Type is set to 2 and no image file is present then the default Dell Wyse logo is
used.
If Type is set to 3, pictures residing in picture subfolder under the home folder
are displayed.
Parameters for wnos INI, {username} INI, and $MAC INI files
57