Setup Guide
Table Of Contents
- Dell Wyse ThinOS Version 8.5 INI Reference Guide
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for wnos INI files only
- Parameters for wnos INI, {username} INI, and $MAC INI files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Table 9. Connection Settings: wnos.ini files, {username} INI, and $MAC INI files (continued)
**AutoSignoff={no, yes}
[Shutdown={no, yes}]
[Reboot={
no, yes}]
Default is no.
AutoSignoff —Yes/no option to automatically sign-off a user
when the last opened session is closed.
Shutdown — Default is no. Yes/no option to shut down the
thin client. If shutdown is set to yes, the ShutdownCounter
value is used to control the count-down before the system is
turned off.
Reboot — Default is no. Yes/no option to reboot the thin
client. If Reboot is set to yes, the ShutdownCounter value
is used to control the count down before the system is
rebooted.
ClearLicense={no, yes}
Default is no.
Yes/no option to clear the TSCAL license stored in the non-
volatile memory. It can be replaced by FixLicense=clean.
Connect={ICA, RDP}
Connect — Connection protocol. Follow the ICA option list,
see ICA Connect Options or RDP option list, see RDP Connect
Options. Any options you use for your connection must be on
the same logical line; \can be used for line continuation, see
Rules and Recommendations for Constructing the INI Files.
ConnectionBroker={default, Microsoft, Quest, VMware} Default is default.
Specifies the Connection Broker type. Select VMware to
enable VDM XML support. If you enter VMware, the VMware
logo appears on the login screen.
For Dell vWorkspace broker, ConnectionBroker=Quest is
recommended.
*Device=Ethernet
[Speed={Auto, 10M HD, 10M FD, 100M HD,
100M FD, or 1000M}
[MTU=mtu]
[KeepAlive={1-600}]
[Warning={
no, yes}]
[StaticIPWaitFileServer={
0-255}]
[WirelessWaitEnet={1-60}]
Device — Specifies to use an Ethernet.
Speed — Default is auto. Specifies the ethernet speed to
either Auto, 10 MHD, 10 M FD, 100 M HD, 100 M FD, or 1000
M. If Speed is set in a wnos.ini file, the Speed statement in the
{username}.ini file will be disabled.
NOTE:
Device and Speed parameters can be replaced by the
EthernetSpeed parameter.
MTU — A maximum transmission unit value between 500 to
1500.
KeepAlive — Specifies a time value in seconds between 1 and
600 to keep an idle connection alive.
Warning — Default is no. Yes/no option to warn about an
idle connection. In the seconds of the specified KeepAlive, if
the tcp connection is idle and Warning=yes, one log will be
printed for the session. For example:
device=ethernet keepalive=20 warning=yes
StaticIPWaitFileServer — Default is 0. Specifies the
timeout threshold in seconds for cases of static IP.
NOTE:
The default 0 turns off this parameter and allows
the system to wait the system default 120 seconds.
If the Speed parameter value is changed, the thin client
requires a reboot.
Parameters for wnos INI, {username} INI, and $MAC INI files 67