Setup Guide

Table 3. General Settings: wnos.ini files only
Parameter Description
201 — Enables firmware upgrade or downgrade process,
but displays a window with OK button before the process;
displays a status complete window.
202 — Enables firmware upgrade only, but displays a window
with OK button before the process; displays a status complete
window.
The option LoadPkg specifies how to update the external
packages.
If set to 0, this disables checking for packages. If set to 1 it
enable packages upgrade/downgrade process, and if set to 2,
it enables upgrade only.
If LoadPkg is not in the statement, it will inherit the value of
AutoLoad. For example, if the value is 0, and if AutoLoad=0,
1, and if AutoLoad=1, 101 or 201, and 2 if AutoLoad=2, 102 or
202.
For example, if you set AutoLoad=1 LoadPkg=0, the firmware
is checked, but the packages are not checked. From ThinOS
8.3, the external packages update mechanism is changed.
Some packages are default, and loaded according to value
of LoadPkg. For example RTME.
Some packages need additional parameter AddPkg to add.
For example, FR and TCX.The option AddPkg is for adding
packages. It depends on the value of LoadPkg.
The packages check comes after firmware check. The option
DelPkg is for deleting packages. It does not depend on the
value of LoadPkg. The packages specified in DelPkg are
always deleted when loading the ini file.
The value of AddPkg and DelPkg is one package name or
a package name list. For example, AutoLoad=1 AddPkg="FR,
TCX" DelPkg=RTME
NOTE:
The AddPkg and DelPkg options depend on
platforms that supports external packages. Only Wyse
3030 LT thin client with ThinOS, Wyse 3030 LT thin
client with PCoIP, Wyse 3040 thin client with ThinOS,
Wyse 3040 thin client with PCoIP, Wyse 5010 thin client
with ThinOS, Wyse 5010 thin client with PCoIP, Wyse
5040 thin client with ThinOS, Wyse 5040 thin client with
PCoIP, Wyse 5060 thin client with ThinOS, Wyse 5060
thin client with PCoIP, and Wyse 7010 thin client with
ThinOS support it. The other legacy platforms does not
support it.
VerifySignature—The option VerifySignature specifies
whether or not the verification is required when updating
the firmware and/or packages. It is introduced in ThinOS
8.4 release and later to enhance the security and integrity
of the firmware and packages. If set to no, it will not check
the signature so that the downgrade of the firmware and/or
packages can happen, which do not support signature. The
default is yes.
UpgradeOrder—This option is a control mechanism to enable
BIOS and firmware upgrade in a specific order.
If parameter is set to no, the default order is set to upgrade
ThinOS firmware first, and then the BIOS.
Parameters for wnos INI files only
11