Setup Guide
Table Of Contents
- Dell Wyse ThinOS Version 8.6 INI Reference Guide
- Contents
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for wnos INI files only
- Parameters for wnos INI, {username} INI, and $MAC INI files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Table 7. Peripheral Settings for wnos.ini Files, {username} INI, and $MAC INI files (continued)
Parameter
* Global overrides identically-named user profile
** After sign off, user profile returns to global value
Description
[EnableSpeaker={yes, no}][
[playback={device name string}]
[record={device name string}]
[mic_gain_device={device name string}]
[mic_gain={1~8}]
[DPaudio=yes,no]
[local_button=yes, no]
[jack_popup=[
yes, no]
[PlayBackEnableList={device name string}]
[RecordEnableList={device name string}]
[EnableReplay=[yes, no]]
0 — no mute
1 — mutes audio
2 — mutes audio and system beep
3 — mutes system beep
mic_vol — Default is medium. Option to set volume levels to
high, middle or low.
high — maximum volume
middle — medium volume
low — minimum volume
Values of 0-25 provide more exact volume level.
mic_mute — Default is no.
no — no mute
yes — mutes audio
mic_ boost — This option increases the mic decibels.
min_cache — Default is 1. This option is for configuring
ThinOS audio playback minimum buffering amount in ten
millisecond units. This can be used when network bandwidth is
not large enough to play audio smoothly.
In such cases, set min_cache higher, so that ThinOS will
buffer more audio data before playing the audio.
1 – ThinOS will buffer at least 10 ms of audio data when
playing audio.
50 – ThinOS will buffer at least 500 ms (0.5s) of audio data
when playing audio.
EnableSpeaker — Default is yes. Yes/no option to enable
the internal loud speaker.
playback — You can set a playback device name.
record — You can set the record device name.
mic_gain_device— Specify the device name on which you
want the mic gain.
mic_gain—Enhances the mic gain by number of times the
specified value. The default value is 1.
Continued from the previous table...
DPaudio=[yes, no]— The default option is DPaudio=yes.
DP audio may impact display on device with certain
screen resolutions such as 1920x1200, 2048x1152, 2048x1280,
2560x1080, 2560x1440 (U2718Q, UP3216Q) however not
limited. User needs to disable DP audio using INI or GUI.
This setting only works for terminals with DP audio support.
local_button=[yes, no] The default option is yes, if the
value is no, the mute/volume up/volume down buttons are
disabled in ThinOS local, but it works during session
60 Parameters for wnos INI, {username} INI, and $MAC INI files