Install Guide

Mounting the client

Use the following instructions to attach the client to the E-series mount:

1 Preparing the client—Use a Phillips-head screwdriver to remove the ller screws from the side of the client and replace them with

the shoulder screws.

2 Removing the cover plates and screws from the monitor.

• Place the monitor panel face down on a soft cloth or cushion.

• Remove cover plate if present.

• Remove the monitor screws from the back of the monitor, and use them when you proceed with installation later.

NOTE

: During installation, position the monitor with the base of the stand hanging over the edge of the table.

6 Mounting the client