Administrator Guide
Table Of Contents
- Dell Wyse ThinOS Lite Release 2.6 Administrator’s Guide
- Introduction
- Before working on ThinOS Lite
- Getting started
- Global connection settings
- Configuring the connectivity
- Configuring the network settings
- Configuring the remote connections
- Configuring the Citrix broker setup
- Configuring the visual settings
- Configuring the general options
- Configuring the authentication settings
- Configuring the central configurations
- Configuring the VPN manager
- Configuring the connection broker
- Configuring Citrix
- Configuring the Citrix broker setup
- Citrix HDX RealTime Multimedia Engine—RTME
- Citrix Icon refresh
- Using multiple audio in Citrix session
- Using Citrix NetScaler with CensorNet MFA authentication
- Okta Integration through Citrix NetScaler
- Configuring ICA connections
- ICA Self Service Password Reset—SSPR
- QUMU or ICA Multimedia URL Redirection
- HTML5 Video Redirection
- ICA SuperCodec
- Anonymous logon
- Configuring the Citrix UPD Printer
- Introduction to Flash Redirection
- Configuring Citrix
- Configuring Zero Client Settings
- Performing Diagnostics
- BIOS Management
- Security Changes
- Creating and Using xen.ini Files
- Examples of Common Printing Configurations
- Important Notes
- Troubleshooting
Figure 10. WLAN settings
a. Add— Use this option to add and configure a new SSID connection.
You can configure the SSID connection from the available security type options.
b. After you configure the SSID connection, the added SSID connection is listed on the page of the WLAN tab.
● Remove — Use this option, if you want to remove a SSID connection by selecting the SSID connection from the list.
● Properties — Use this option to view and configure the authentication properties of a SSID connection that is
displayed in the list. From the ThinOS Lite 2.3 release, a new EAP type named EAP-Fast is added in the EAP
type drop-down list. During the initial connection, when there is a request for a Tunnel PAC from the authenticator,
the PAC is used to complete the authentication. Therefore, the first time connection always fails and the following
connections succeed.
Only automatic PAC provisioning is supported from 2.3 release. The user/machine PAC provisioning generated with Cisco
EAP-FAST utility is not supported.
34
Configuring the connectivity