Install Guide

3 Installing X Class Flash
This chapter contains information for users of Wyse X class mobile thin clients who must
install new flash.
Requirements
• Small Phillips screwdriver
WARNING: Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD. Before you
remove or install a module, touch any metal part of the chassis and keep that contact with
the chassis during the installation process.
Procedures
CAUTION: Follow all precautions listed in the Quick-Start Guide that came with your
mobile thin client for disconnecting and reconnecting the mobile thin client.
1. Perform a proper shutdown of the mobile thin client by closing all files and ending your
session, and then pressing the power button to turn off the mobile thin client.
2. Unplug the power cord and power adapter, and then remove any other cables from the
mobile thin client.
3. Position the mobile thin client to access the bottom cover, and then remove the screws
from the cover using a small Phillips screwdriver as shown in Figure 6.
Figure 6 Removing the bottom cover screws
4. Lift the bottom cover to remove it and expose the flash module as shown in Figure 7.