Install Guide

8 Chapter 3
5. Remove the existing flash module. Locate the flash module and use the Phillips
Screwdriver to remove its retaining screw as shown in Figure 7. Lift the flash module
out of the socket.
Figure 7 Removing the existing flash module
6. Install the new flash module in the reverse order of removing the original flash module.
Carefully screw down its retaining screw until it is secure.
WARNING: Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD. Before you
remove or install a module, touch any metal part of the chassis and keep that contact
with the chassis during the installation process.
7. Replace the flash cover in the reverse order as described in steps 4 and 3.
CAUTION: Do not turn on the mobile thin client. The mobile thin client is ready to
re-image, however the flash module does not contain an operating system. Turning on
power to your mobile thin client without firmware will display the error message “NO
OPERATING SYSTEM FOUND.”
What’s Next
Continue with "Installing Firmware."