Reference Guide

NOTE:
If EnableRAVE=no or this parameter is not present, the TCX
Multimedia will be used for all media les. If
EnableRAVE=yes, RAVE will be used only for media les it
supports.
EnableRAVE=yes is ignored unless a valid TCX Multimedia
license is used.
FileServer=List of {IP address, DNS name}
[Username=username]
[Password=password]
[SecurityMode={Low, Warning, Full, default}]
FileServer — Species the FTP or Web (http://) server IP address
or DNS name that is entered into thin client local setup (non-volatile
memory); the thin client immediately uses this server to access
les.
Username — Species the username of the le server.
Password — Species the password of the le server.
NOTE:
The target le server must support access using the same
user credentials used in the INI les.
The optional keyword Username and Password specify the
username/password of the le server. When the client fetches the
WNOS.INI le from a HTTPS server, ThinOS supports dierent
security modes. The default follows SecurityPolicy and may be one
of the three modes. The option SecurityMode species these
security modes.
SecurityMode — Species the security level for the le server
during client verication of the server certicate. This option is only
valid when connecting to an https le server.
When conguring the https le server, the Username and
Password options of the FileServer parameter can be omitted. Use
the following guidelines:
• Set SecurityMode=Full to have the client verify the server
certicate in highest security mode; if any error occurs during
verication, the client will not connect to the server and a pop-
up message is displayed.
• Set SecurityMode=Warning to have the client provide a
warning when the client cannot verify the server certicate, but
still allow the user to select to continue client connection to the
server.
• Set SecurityMode=Low to indicate that the client allows
connection without any certicate verication.
• Set SecurityMode=Default to indicate that the client follows
SecurityPolicy settings to check certicate.
• Default value of the setting is Default. If the settings are factory
default or if you are upgrading to ThinOS 8.3 for the rst time,
the value is temporarily set to None. After loading any INI, it
goes to default.
• If the security mode value in WNOS.INI is not the same as the
one saved in Client NVRAM, client shows a reboot dialog box.
Parameters for WNOS INI Files Only
25