Reference Guide
Connect Parameter: Options
This appendix provides the supported options for the Connect parameter in the following supported connections:
• ICA Connect Options
• RDP Connect Options
Topics:
• ICA Connect Options
• RDP Connect Options
ICA Connect Options
Table shown here contains the supported options used for ICA connections (after you use the Connect=ICA parameter/selection).
IMPORTANT
:
If an option has an underlined value (default), that option and default value will automatically be used with Connect=ICA; options
without underlined values can also be used if you want to, but are not automatically used with Connect=ICA. In addition, when using
options, you can leave the default value or change it to another value shown.
For example, in the following case where:
Connect=ICA
[Option1={0, 1}]
[Option2={1, 2, 3, 4}]
Since you are using Connect=ICA, then Option1 and its default value 0 will automatically be used as Option1 has an underlined value
(default of 0). You can still use Option2 if you want to, however, Option2 is not automatically used with the parameter as Option2 does
not have a default value.
NOTE:
Any option in Table 8: ICA Connect Options that is used in a {username}.ini le will return to the default value set for that option in the
wnos.ini le after a user sign-o. For example, if your {username}.ini le contains the option Reconnect=yes so that a lost connection
will restart 20 seconds after disconnection; and you sign o the thin client, then the Reconnect value will return to the original default
value of no (Reconnect=no) contained in the wnos.ini le—so that others who sign in can use their own user prole; assuming the
administrator has not changed the default values in the wnos.ini.
A
Connect Parameter: Options 83