Deployment Guide
Table Of Contents
- Dell Wyse ThinOS Version 8.5 Hotfix INI Reference Guide
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for wnos INI files only
- Parameters for wnos INI, {username} INI, and $MAC INI files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Table 8. Peripheral Settings for wnos.ini Files, {username} INI, and $MAC INI files (continued)
Parameter
* Global overrides identically-named user profile
** After sign off, user profile returns to global value
Description
If optimize=no then the individual settings in width, height,
and fps will be used as long as the camera supports them.
Disable— When you specify Disable=yes, the device is
disabled. For example, the Camera tab in peripherals setting
is disabled, the Exclude video devices option in Global
Connection Settings is disabled. The device cannot be
accessed at local and remote sessions.
**Device=keyboard
[numlockoff={no, yes}]
[repeatrate={0,
1, 2}]
[repeatdelay={0, 1, 2, 3, 4, 5, 6, 7}]
Device — Specifies the local keyboard.
numlockoff — Default is no. Yes/no option to turn off the
NumLock of the keyboard.
repeatrate — Default is 1. Specifies the keyboard repeat
rate.
0 — Slow
1 — Medium
2 — Fast
repeatdelay — Default is 2. Specifies the keyboard delay in
seconds, before repeat.
0 — 1/5
1 — 1/4
2 — 1/3
3 — 1/2
4 — 3/4
5 — 1
6 — 2
7 — No Repeat
NOTE:
These settings in a wnos.ini file are saved into NVRAM if
EnableLocal is set to yes in the wnos.ini file.
Device=mouse
[Speed=[1-9]]
[Swap={yes,
no}]
[FlipFlopWheel={yes, no}]
Speed is used to configure the speed of the moving mouse.
1 is the slowest, 9 is the fastest. The default value is 6. This
parameter is the replacement of MouseSpeed.
If the option Swap is set to yes, the right button is set as the
primary button. The default value is no.
If the option FlipFlopWheel is set to yes the mouse scroll
wheel is inverted. The default value is no.
Device=Rfideas
[DisableBeep={yes, no}]
[DisableKeystroke={
yes, no}]
[SetCardType={yes, no} Configuration1={*}
Configuration2={*} ]
[DisableInitialization={yes, no}]
[DisableLed={yes, no}
Device=Rfideas — Specifies the local Rfideas readers.
DisableBeep — Default is yes. Option disables the beep
sound when the card is read.
DisableKeyStroke — Default is yes. Option disables the
keyboard movements and key strokes.
SetCardType — Default is no. Used only for pcProx Plug
readers.
62 Parameters for wnos INI, {username} INI, and $MAC INI files