Setup Guide
Table Of Contents
- Dell Wyse ThinOS Version 8.5 INI Reference Guide
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for wnos INI files only
- Parameters for wnos INI, {username} INI, and $MAC INI files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Table 6. Connection Settings: wnos.ini files only (continued)
VDI example:
ConnectionBroker=VDM
SelectServerList=VDI; Default=test5
description = test4; host = 192.168.0.11;
description = test5; host = host2.wyse.com
The Default option following "SelectServerList={PNA, VDI}"
can specify the default server. The value is one of server
description defined after that. After one selects another
server and sign off, this default server is selected. If default
option is not specified, the last selected server is selected in
the next sign on.
Service={snmpd, thinprint, vncd, wdm,
vda <port number>} disable={no, yes}
Service — Specifies the services you can enable or disable;
there are different syntaxes for the different services.
disable — Default is no. Yes/no option to disable the
services. Disable must follow the Service parameter.
Service=snmpd disable={no, yes}
[community=<snmp_community> [encrypt={yes, no}]]
[communityReadOnly=<snmp_community_read_only>
[encrypt={yes,
no}]]
[servers=server_list]
Default is no.
Service=snmpd disable — Yes/no option to disable the
snmpd service.
community — The option community is same as the
statement Community. encrypt option is same as that in the
statement community.
communityReadOnly— This option is to set community only
has snmp get and get_next privileges. The following encrypt
option is only for indicating, if value of communityReadOnly is
encrypted.
Servers —This option is set to limit the valid snmp
management site to the IP addresses in the server_list
parameter, which contains 1 to 4 IPv4 IP addresses currently.
If not, all the set IP addresses seen as valid.
Service=thinprint disable={
no, yes}
[port=<port number>]
[PkSize={0-64000}]
Default is no.
Service=thinprint disable — Yes/no option to disable the
thinprint service.
port — Same as the statement ThinPrintEnable={no, yes}
port=portnumber.
PkSize — Specifies the default packet size that will be sent
to the server when negotiating with the thinprint server.
The value 0 will rely on the server default setting, 64000 in
ThinPrint 7.6 and 32000 in previous ThinPrint versions.
ThinOS only allocates a buffer of 64K, so if the default packet
size of the server is above 64000, this setting must be set or
printing will fail.
Service=vncd disable={no, yes}
[servers=server_list]
Service=vncd disable—Yes/no option to disable the vncd
service, same as MaxVncd={0, 1}.
Default is no.
servers—Use the servers option to limit the valid vncd
client site to the IP addresses in the server_list parameter,
which contains IPv4 IP or IP range addresses, such as
192.168.1.0/24; 192.168.2.48.
If this option is not set, then all IP addresses are displayed as
valid.
Parameters for wnos INI files only 35