Setup Guide

Table 9. Connection Settings: wnos.ini files, {username} INI, and $MAC INI files (continued)
WirelessWaitEnet—This option specifies the wait period
before the wireless initializes in case of Enet Up. The default
value is 5.
Device=vusb
[ForceRedirect=DeviceID]
[ForceLocal=DeviceID]
[Type={TCX, HDX}]
[InterfaceRedirect={
no, yes}]
Device — Specifies the ID of a local USB device that is not
redirected by default.
ForceRedirect — Specifies a forced redirect of the local
USB device to the server. This parameter has priority over
ForceLocal.
ForceLocal — Specifies that the local USB device should not
be redirected to the server. The DeviceID can be found in the
event log. For example, if you find TCX USB: Local Device
(0x04f2,0x0112,0x03,0x01,0x01), set the parameter as:
Device=vusb
ForceRedirect=0x04f2,0x0112,0x03,0x01,0x01
Type —For Citrix Environments Only. This option allows
you to force the usage of HDX for USB virtualization. For
example:
Device=vusb Type=HDX
NOTE:
To use the TCX option, TCX Suite must be install on the
target server.
InterfaceRedirect — Default is no. Yes/no option to enable
part of a composite device to run locally and part of the
device to run on a remote session.
Device=Wireless
[Mode={Infrastructure, AdHoc}]
[SSID=ssid Channel={1-14}]
[WepKey={
None, 1-4}]
[Key1=k1]
[Key2=k2]
[Key3=k3]
[Key4=k4]
[Key1Enc=key1 encrypted]
[Key2Enc=key2 encrypted]
[Key3Enc=key3 encrypted]
[Key4Enc=key4 encrypted]
[RoamSensitive={high, medium, low}]
[Algorithm={Open, SharedKey}]
[DisableBand={
None, 2.4G, 5G}]
[PreferBand={None, 2.4G, 5G}]
[Priority=ssid_list]
[DisableN={
no, yes}]
[DisableWlan={yes, no, EnetUp}]
Device — Defines the wireless Ethernet device remotely and
saves to the local NVRAM. Not all options are needed. For
example, you can define Key 1 to have a key of k1 and leave
out Key 2 through Key 4.
NOTE: See also IEEE8021X={yes, no}.
General example:
device=wireless SSID=THINOS
RoamSensitive=low
k1 to k4 are any real values of 5 to 13 characters or 10
to 26 Hex digits. Encrypted keys will overwrite unencrypted
keys. Thus, if both Key1 and Key1 Encare are configured, then
Key1Enc will overwrite Key1.
RoamSensitive — Defines the sensitivity level of wireless
roaming with respect to launching the Roaming daemon:
high - signal lower than -60 dBm
medium - signal lower than -70 dBm
low - signal lower than -80dBm
The RoamSensitive parameter is also used to enable wireless
roaming. If it is not configured in the INI file, roaming will
never be launched even if the signal is lower than -80dbm,
unless it totally loses a wireless signal.
Algorithm — Specifies the authentication method of WEP
between ThinOS and the access point. If set to Open, open
68
Parameters for wnos INI, {username} INI, and $MAC INI files