Administrator Guide

● ThinOS supports only the DisplayPort audio playback. Audio recording using DisplayPort is not supported.
● DisplayPort audio is supported only on Wyse 3030 LT thin client, Wyse 3040 thin client, and Wyse 5060 thin client.
Disabling DisplayPort audio
In Wyse 3040 thin client, the DP audio is enabled by default. However, in certain resolution, such as, 1920 x 1200, 2048 x 1152,
2048 x 1280, 2560 x 1080, 2560 x 1440, a black screen is displayed for 10 seconds after you restart the thin client. In such
scenarios, disable the DP audio option.
To disable DP audio, do the following:
1. On the ThinOS desktop, click System Setup > Peripherals > Audio. By default, the DP audio is enabled.
2. Clear the Enable DP audio check box, and click Yes. If you click No, the thin client will not restart, and the DP audio is
enabled.
3. After the system restart, navigate to System Setup > Peripherals > Audio > Playback Devices, and ensure that the
LPEDP audio option is not configured.
Configuring the serial settings
To configure the Serial settings:
1. From the desktop menu, click System Setup, and then click Peripherals.
The Peripherals dialog box is displayed.
2. Click the Serial tab and do the following:
a. Select Port—Click the button to select the Port. Default is COM 1.
b. Baud Rate—Select the Baud Rate from the drop-down list. Default is 9600.
c. Parity—Click the button to select the Parity.
d. Stop—Click the button to select the stop bits 1, 1.5, 2. Default value is 1.
e. Size—Click the button to select the Character size 5, 6, 7, or 8 bits. Default is 8.
f. Flow Control—Click the button to select Flow Control: Either None, XON/XOFF, CTS/RTS, or Both can be selected.
Default is None.
g. Serial Touch Screen selections—Select the required touch screen from the drop-down list. Available options are ELO,
MicroTouch and FastPoint.
h. Touch Screen on—Select the required serial port (COM port) or None from the drop-down list.
3. Click OK to save the settings.
120
Configuring thin client settings