Administrator Guide

If your monitor is not DDC compatible, then Monitor does not support Plug and Play message is displayed. Click OK
to acknowledge the message and remove it from the screen.
b. DDC table—If the monitor is VESA DDC2B (Display Data Channel) compatible, selection of this option allows you to
select the resolution and refresh rate you want from the list.
c. User defined display setting—Select this option and select the resolution and refresh rate supported by your monitor.
All combinations are allowed.
Resolutions include:
640 x 480
800 x 600
1024 x 768
1152 x 864
1280 x 720
1280 x 768
1280 x 1024
1360 x 768
1366 x 768
1368 x 768
1400 x 1050
1440 x 900
1600 x 900
1600 x 1200
1680 x 1050
1920 x 1080
1920 x 1200
1920 x 1440
2560 x 1080
2560 x 1440
2560 x 1600
3440 x 1440 (Display resolution supported on Wyse 5010 and 5060 thin clients)
3840 x 2160
d. Rotation—Select a rotation option. The available options are None, Left turn 90 degrees, or Right turn 90 degrees.
e. Desktop Color—Only 32-bit is permitted. This value is selected by default.
f. Usage Help—This section contains brief instructions for using the Display dialog box and running the test. No operator
entry can be made in this box.
Make note of the instructions in the area, regarding v-key reset usage if there is display failure.
3. Click OK to save the settings.
For information about the tested monitors, see the latest Dell Wyse ThinOS Release Notes.
Configuring the Dual Head display settings
This section is not applicable to Wyse 5070 thin client. To configure the Dual Head display settings:
1. From the desktop menu, click System Setup, and then click Display.
The Display dialog box is displayed.
2. Click Dual Head tab, and use the following guidelines:
166
Configuring local settings