Users Guide
Table Of Contents
- Dell Wyse 5070 Thin Client User Guide
- Contents
- Welcome to Dell Wyse 5070 thin client
- Chassis overview
- Major components of your thin client
- Supported system peripherals for Wyse 5070 thin client
- Setting up the thin client
- Before working on your thin client
- After working on your thin client
- Removing and installing components
- Technical specifications
- Wyse 5070 thin client configuration on ThinOS
- Wyse 5070 thin client on ThinLinux
- Wyse 5070 thin client on Windows 10 IoT Enterprise
- BIOS overview
- Accessing thin client BIOS settings
- System Setup overview
- Boot Sequence
- Navigation keys
- General screen options
- System Configuration screen options
- Video screen option
- Security screen options
- Secure Boot screen options
- Performance screen options
- Power management screen options
- POST behavior screen options
- Wireless screen option
- Virtualization support screen options
- Maintenance screen options
- System Logs screen option
- Troubleshooting your system
Table 12. Keyboard parameters
Parameter Description
Character Set Lists the character sets. Each character is represented by
a number. The ASCII character set, for example, uses the
numbers 0 through 127 to represent all English characters
and special control characters. European ISO character sets
are similar to ASCII, but they contain additional characters
for European languages.
Keyboard Layout Presently the keyboard languages listed in the Keyboard
layout drop-down list are supported. The default value is
English (United States).
Delay Before Repeat Lists the repeat parameters. Select Delay Before Repeat
value as either 1/5 second, 1/4 second, 1/3 second, 1/2
second, 3/4 second, 1 second, 2 seconds, or No Repeat.
The default is 1/3 second.
Repeat Rate Select Slow, Normal, or Fast. The default value is
Medium.
3. Click OK to save the settings.
Configuring the mouse settings
To configure the mouse settings:
1. From the desktop menu, click System Setup, and then click Peripherals.
The Peripherals dialog box is displayed.
2. Click the Mouse tab, select the mouse speed and mouse orientation.
3. Select the Swap left and right mouse buttons check box to swap mouse buttons for left-handed operations.
4. Click OK to save the settings.
Configuring the display setup
Use the Display Setup dialog box to configure the display settings for the connected monitors.
To configure the display setup:
1. From the desktop menu, click System Setup, and then click Display.
The Display Setup dialog box is displayed.
2. In the Display Setup dialog box, configure the following options:
● Mirror mode—Select the Mirror mode check box to enable all connected monitors to use the same display settings
configured on the primary monitor.
The following screen represents the Mirror mode configuration.
If you clear the Mirror mode check box, the Span Mode is enabled. The following screen represents the span mode
configuration.
Blocks displayed on the screen represent the number of monitor screens connected to thin client. Each block represents
a single monitor screen.
Every monitor contains a unique display order number and display configuration. To construct a new display layout, move
the blocks to your preferred position, and click Apply. A new display layout is created. However, the system sets the
block to its default position if the block is moved to an incorrect position.
NOTE: Wyse 5070 thin client supports up to six monitors.
● Main screen—Select the Main screen check box to set the monitor as primary monitor or main screen. To set a
monitor as main screen, click the monitor block, and select the Main screen check box. After you set the monitor as
main screen, the monitor block is highlighted with an underline, and the Main screen option is disabled for that monitor
block. The Main screen option is available for other monitor blocks.
NOTE: Main screen option is effective only in Span Mode and always disabled in Mirror Mode.
40 Wyse 5070 thin client configuration on ThinOS