Administrator Guide

4. Click OK.
5. Go to System Setup > Remote Connection > General Options.
6. Enter the default sign-on username, password, and domain.
7. Click OK.
Configuring the central configurations
Use the Central Configuration dialog box to configure the Wyse Management Suite server settings.
Configure the Wyse Management Suite settings
About this task
This section describes how to configure the Wyse Management Suite settings on your thin client.
Steps
1. From the desktop menu, click System Setup > Central Configuration.
The Central Configuration dialog box is displayed.
2. On the WMS tab, do the following:
Figure 22. Wyse Management Suite
a. Select the Enable Wyse Management Suite (WMS) check box to enable the Wyse Management Suite to discover
your thin client. By default, this option is selected. Wyse Management Suite service automatically runs after the client
boots.
NOTE:
If the first discovery, for example, the Wyse Management Suite service is not successful, it continues until a
discovery is successful. If all discoveries fail, it is started again automatically.
b. Select the DNS SRV record check box if you want the thin client to obtain the Wyse Management Suite values through
DNS server, and then try to register into the Wyse Management Suite server. By default, the check box is selected. If
the check box selection is canceled, the thin client cannot obtain the Wyse Management Suite values through the DNS
server.
Configuring connectivity
63