Reference Guide

Parameter Description
[DisableShowServer=[yes,no]
[EnableUnauthenticatedAccess]={yes,no}
[Host={broker_url}]
[AutoConnectList={*|host1;host2;host3...}]
[VMWaitTimer={0–3600}]
• Set SecurityMode=Warning to have the Client allow connection continuation in
the following two specific exceptions where full verification would fail:
1. Certificate is self-signed.
2. Certificate has an invalid time.
• Set SecurityMode=Low to indicate that Client allows connection without any
certificate verification.
• Set SecurityMode=Default to indicate that Client follows the SecurityPolicy
setting to verify the certificate.
NOTE:
For Dell vWorkspace broker, ConnectionBroker=Quest is recommended.
EnableVWGateway and VWGateway are used to set the vWorkspace
gateway.
For VMware broker, ConnectionBroker=VMware is recommended.
ConnectionBroker=VDM is still supported but deprecated.
The option ConnectionType specifies the display protocol that you want to use
when launching a session in VMware broker. If this parameter is set, then the
desktops that meet the specified protocol are listed after broker sign on.
This setting is only valid in case of PCoIP feature is supported.
• Set ConnectionType=Default, only the desktops with the default protocol
configured in broker server are listed (this is the default value for this setting).
• If you set ConnectionType=All, both PCoIP and RDP desktops are listed.
• If you set ConnectionType=RDP, only RDP desktops are listed.
• If you set ConnectionType=PCoIP, only PCoIP desktops are listed.
• If you set ConnectionType=Blast, only Blast desktops are listed.
EnableVDMCredSSP=yes—The option is set to yes to enable RDP NLA mode
connection when the VMware View broker session is launched. The default value is
no. EnableVDMCredSSP=yes works only after you disable view security tunnel in
server side.
RDCollections—The option specifies the collections for Microsoft RD broker. Only
the applications and desktops within the specified collections are displayed. The
value can be a list separated by ',' or ';' and can use wildcard "*" to match the
string. If the parameter is not set, all the applications and desktops are displayed. To
get your RemoteApp or desktops collection name, do the following:
1. In RDS Server local, go to C:\Users\administrator.RDSS\AppData
\Roaming\Microsoft\Workspaces\{xxxx}\Resource, and check
that all your published collection (.rdp file) are listed.
2. Open the specify .rdp file which you want to define in .ini file with notepad and
get the collection name from line "loadbalanceinfo:s:tsv://MS
Terminal Services Plugin.1.[collection name]".
Continued from the previous table...
DisableShowDisclaimer=yes—The option is set to yes to disable popup/pre-
logon message and automatically accept them without intervention when broker
type is VMware View. The default value is no.
DisableShowServer=yes—The option is set to yes to disable showing the view
server URL in sign-on window and disclaimer window when broker type is VMware
View. The default value is no.
EnableUnauthenticateAccess=yes—The option Yes is set to enable the
VMware View broker log. The default value is No.
The option Host specifies the connection broker server IP address or FQDN.
The option AutoConnectList specifies the VDI desktops or applications which
automatically launches when you use VDI to sign in. If the option is set to *, all the
20 Parameters for wnos INI files only