Administrator Guide

Figure 7. General tab

a) To set the default gateway, select the type of network interface from the following options:

• ENET— Enables you to set up the Ethernet Wired Network connection.

• WLAN—Enables you to set up the Wi-Fi connection.

NOTE:

If both wireless and wired networks are connected, the default gateway is determined by the UI settings.

The Wyse 5470 Thin Client supports the following two networks simultaneously:

• Internal Network Interface Card (NIC) and the NIC on the docking station.

• Internal NIC and Wi-Fi

NOTE:

A combination of internal NIC + NIC on the docking station + Wi-Fi is not supported.

b) Use Static Name Servers—By default, this check box is not selected, and thin client fetches the server IP address from DHCP.

Select this check box to manually assign static IP addresses.

If name servers are changed using GUI, INI or link down/up, then the details are displayed in Event Logs.

In dynamic mode, the DNS/WINS can be merged from Ethernet 0 and Ethernet 1, if network is not working.

1. Enter the URL address of the DNS Domain in the DNS Domain box.

2. Enter the IP address of the DNS Server in the DNS Server box.

Configuring connectivity