Administrator Guide

Table 7. Parameters to configure nodes

Parameter Values

Name:<name of the application> [Application name]

Path:<path of the application> [Application path]

Arguments:< specify the configuration information when the

application is launched>

[Argument]

Event:<event to execute the command>

USER_LOGOFF

SVC_STARTUP

ON_SHUTDOWN

USER_LOGIN

Examples to configure nodes using xDCM

Table 8. Examples to configure nodes using xDCM

Scenario Command

Adding an application node that is used by ClientServiceEngine

service to run the TestApp.exe file with an argument -t when

you log off from the system.

ALM.exe -Add -Application -Name:ExampleApp -

Path:C:\Windows\System32\TestApp.exe -

Arguments:"-t" -Event: USER_LOGOFF

Deleting an application node from ExampleApp application.

ALM.exe -Remove -Application -Name: ExampleApp

NOTE:

• You must provide unique names to add a new application entry to the ApplicationLaunchConfig.xml using

ALM.exe.

• Only three execution event values USER_LOGOFF, SVC_STARTUP, and ON_SHUTDOWN, are supported in the ALM

application. You can add only one of these values to each event.

xData Cleanup Manager

xData Cleanup Manager (xDCM) version 1.0 prevents extraneous information from being stored on the local disk. xDCM can be used to

automatically clean up directories used to temporarily cache the information. A clean up is triggered on either service startup, user logoff,

or system shutdown.

It also enables you to configure multilevel logs which are essential for troubleshooting. You can clean up files, folders, and enable or disable

xDCM using Application Programming Interface (API). You can also add or remove configuration nodes from the xDCM configuration file

using command-line interface.

NOTE:

• Existing NetXclean.ini configurations are ported to new xDataCleanupConfig.xml.

• Content in the xData Cleanup Manager are cleaned by default.

xDCM CLI tool

You can use the xDCM CLI tool to add or remove configuration nodes from xDCM configuration file XdataCleanupConfig.xml. This

tool is available at the installation path of the xDCM application. By default, the tool is available at %systemdrive%\Program Files

\XDCM.

Configuration of nodes using xDCM

You can use the following options and parameters to configure application nodes in XdataCleanupConfig.xml:

Additional administrator utility and settings information