Service Manual

Steps

1. Align the notch on the memory module with the tab on the memory module slot.

2. Slide the memory module firmly into the slot at an angle.

3. Press the memory module down until the clips secure it.

NOTE: If you do not hear the click, remove the memory module and reinstall it.

Next steps

1. Installing the battery.

2. Installing the base cover.

3. Installing the SD memory card.

4. Follow the procedure in After working on your thin client.

Solid-state drive

Removing the M.2 solid-state drive

Prerequisites

1. Follow the procedure in Before working on your thin client.

2. Removing the SD memory card.

3. Removing the base cover.

4. Removing the battery.

About this task

The following image indicates the location of the M.2 solid-state drive and provides a visual representation of the removal procedure:

Removing and installing components