Service Manual

Steps

1. Remove the three screws (M2x2) that secure the touch pad bracket to the palm-rest and keyboard assembly.

2. Peel the tape that secures the bracket.

3. Lift the touch pad bracket off the palm-rest and keyboard assembly.

4. Open the latch and disconnect the touch pad cable from the system board.

5. Peel the touch pad cable off the palm-rest and keyboard assembly

6. Remove the four screws (M2x2) that secure the touch pad to the palm-rest and keyboard assembly.

7. Peel the two tapes that secure the touch pad.

8. Lift the touch pad off the palm-rest and keyboard assembly.

Installing the touch pad assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the touch pad assembly and provides a visual representation of the installation procedure:

Removing and installing components