Service Manual

Steps

1. Align the screw holes on the VGA daughterboard with the screw holes on the palm-rest and keyboard assembly.

2. Replace the two screws (M2x3) that secure the VGA daughterboard on the palm-rest and keyboard assembly.

3. Connect the VGA board cable to the system board.

4. Route the display cable through the routing guide.

5. Connect the display cable to the system board.

6. Slide the CAC reader cable to the respective port on the system board and close the latch to secure the cable.

Next steps

1. Installing the battery.

2. Installing the base cover.

3. Installing the SD memory card.

4. Follow the procedure in After working on your thin client.

Display assembly

Removing the display assembly

Prerequisites

1. Follow the procedure in Before working on your thin client.

2. Removing the SD memory card.

3. Removing the base cover.

4. Removing the battery.

5. Removing the WLAN.

Removing and installing components