Service Manual

Steps

1. Remove the three screws (M2.5x5) that secure the right hinge to the system board, and palm-rest and keyboard assembly.

2. Lift the right hinge from the system board, and the palm-rest and keyboard assembly.

3. Disconnect the power adapter cable from the system board.

4. Remove the power adapter cable from the routing guide.

5. Remove the screw (M2x3) that secures the power adapter port to the palm-rest and keyboard assembly.

6. Lift the power adapter port with the cable from the palm-rest and keyboard assembly.

Installing the power adapter port

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the power adapter port and provides a visual representation of the installation procedure:

Removing and installing components