Administrator Guide

○ To exit the Attach the Ethernet cable screen, and load the ThinOS system desktop, click Exit.
After the connection is established, the thin client validates the IP address from DHCP. If the DHCP contains the file server
or the Wyse Device Manager or Wyse Management Suite configurations, then the ThinOS system desktop is loaded. If the
DHCP validation fails, or the network connection fails, then the Management Configuration screen is displayed. Follow
steps 6–9.
5. Click Next to enter the Management Configuration setup.
6. On the Management Configuration screen, configure the following:
● File Server—Enter the file server details to apply configurations including INI files, firmware, packages, and so on, from
a file server.
● WMS—Enter the group registration key and the Wyse Management Suite server URL to register the thin client to the
Wyse Management Suite.
● WDM—Enter the IP addresses or host names.
● Disable SSL warning—Select this check box to disable the SSL (Secure Sockets Layer) connection warnings.
● Certificates Manager—Click Certificates Manager to import or request a certificate.
NOTE: To exit the Management Configuration screen, and load the ThinOS system desktop, click Exit.
7. Click Done to exit the First Boot Wizard or click Next to enter the Connection Broker Configuration setup.
8. On the Connection Broker Configuration screen, configure the following:
14
Getting started