Setup Guide

Table 8. Peripheral Settings for wnos.ini Files, {username} INI, and $MAC INI files (continued)
Parameter
* Global overrides identically-named user profile
** After sign off, user profile returns to global value
Description
**RepeatDelay={0, 1, 2, 3, 4, 5, 6, 7}
Default is 2. Specifies the keyboard delay before repeat in
seconds.
0 — 1/5
1 — 1/4
2 — 1/3
3 — 1/2
4 — 3/4
5 — 1
6 — 2
7 — No Repeat
**RepeatRate={0, 1, 2}
Default is 1. Specifies the keyboard repeat rate.
0 — Slow
1 — Medium
2 — Fast
*Resolution=[DDC, 640X480, 800X600,
1024X768, 1152X864, 1280X720,
1280X768, 1280X1024, 1360X768,
1366X768, 1368X768, 1400X1050,
1440X900, 1600X900, 1600X1200,
1680X1050, 1920X1080, 1920X1200]
[Refresh=60, 75, 85}
[rotate={right}]
[align={screen id,top|center|bottom|left|right,top|center|
bottom|left|right}]
Default is DDC.
Resolution — Specifies the local display resolution. Option
DDC can be specified to select default display resolution.
NOTE:
When using the Wyse Y Cable, DDC will properly work on
both monitors by default. However, if connected to
R10L/R00x clients and you are using Dual DVI, then you
must add the following DualHead INI parameter and
DualHead option for DDC to properly work on both
monitors:
Parameter: DualHead=yes
Option: ManualOverride=yes
Refresh — Specifies the local display refresh rate.
NOTE:
If the Resolution or Refresh parameter values are
changed, the thin client will reboot without notice to the
user.
rotate — Rotate allows you to rotate monitors for viewing in
Portrait mode. For example:
screen=1 resolution=1280x1024 refresh=60
rotate=none
NOTE:
Due to processing power requirements, rotate is not
recommended and supported on the C class platforms at
this time.
NOTE:
Parameters for wnos INI, {username} INI, and $MAC INI files 69