Reference Guide

ManualsBrandsDell ManualsConverged InfrastructureWyse 7040 Thin Client

TPM rmware version 1.2 to version 2.0 upgrade

instructions for Wyse 7040 thin client

New releases are created to support new hardware platforms, correct defects, make enhancements, or add new features. These releases

are tested and supported on current, actively shipping hardware platforms, and those hardware platforms that are within their rst year

after their ocial End-of-Life date, as applicable. After the one year time period, new software releases are no longer certied for use with

the earlier version of the hardware, even though it is possible that they may still work. This allows us to advance our product with features

and functions that might not have been supported by the previous hardware, with previous generation CPUs and supporting components.

Contents

Purpose/Background......................................................................................................................................................... 1

Pre-requisites ..................................................................................................................................................................... 1

Supported platforms...........................................................................................................................................................1

Requirements.......................................................................................................................................................................1

Upgrade instructions..........................................................................................................................................................2

TPM update procedure using DOS environment........................................................................................................... 3

Purpose/Background

Change or upgrade from an existing operating system to a newer operating system requires an update to Trusted Platform Module (TPM).

NOTE: For more information about Trusted Platform Technology, go to Dell TechCenter Client TPM WIKI.

Pre-requisites

TPM upgrade is required for select Dell systems, if the operating system that runs on the system is upgraded to Windows 10 IoT Enterprise.

• Windows Embedded Standard 7P systems require TPM rmware version 1.2

• Windows 10 Enterprise systems can use either TPM rmware version 1.2 or 2.0

Supported platforms

Wyse 7040 thin client supports TPM upgrade.

Requirements

NOTE

: While performing TPM upgrade, make sure that you do not turn o the power and then turn on again. Any power

disruption that occurs may damage the TPM module during upgrade. If disruption occurs, then the data in hard drive cannot be

accessible and system is not usable.

Systems that shipped with Windows Embedded standard 7P OS from the factory has TPM rmware 1.2. Such systems require Dell TPM

2.0 Update Utility to upgrade the TPM rmware version to version 2.0.

2017 - 01

TPM rmware version 1.2 to version 2.0 upgrade instructions for Wyse 7040 thin client 1

Summary of content (3 pages)

PAGE 1
2017 - 01 TPM firmware version 1.2 to version 2.0 upgrade instructions for Wyse 7040 thin client New releases are created to support new hardware platforms, correct defects, make enhancements, or add new features. These releases are tested and supported on current, actively shipping hardware platforms, and those hardware platforms that are within their first year after their official End-of-Life date, as applicable.
PAGE 2
For more information about upgrade instructions for the update utility, see the Upgrade instructions section. Upgrade instructions Use the Dell TPM Update Utility for Windows/ DOS to perform the TPM upgrade. To update the TPM firmware version 1.2 to version 2.0, do the following: 1 Go to Dell TPM 2.0 Update Utility, and download the TPM upgrade utility application file. 2 When the File Download window is displayed, click Save to save the file to your USB mass storage device.
PAGE 3
b On the desktop, double-click the Dell Wyse WF Enable icon. Write filter is enabled and system reboots. System automatically logs in to user account because the auto logon is enabled for the User account on the system. TPM firmware upgrade is complete, and the firmware version is upgraded from version 1.2 to version 2.0.