Administrator Guide

Figure 55. Repository capable

4 After you congure the device to be Repository Capable, the Repository Capable ag is set to Green as displayed below:

Figure 56. Repository capable

Creating PAD Capable Images for Windows Devices

To create a PAD capable image for WES7, WE8S and WIE10 devices:

1 Set the device check-in interval to at least one hour in the WDM GUI Preferences.

2 Log in to the device as an Administrator, disable the Write Filter, log out , and log in again as Administrator.

3 Delete the HagentSettings.ini le from C:\Program Files\Wyse\WDA\cong and run the following command in the command prompt

for WES7 devices:

Hagent.exe -Install

For WE8S and WIE10 devices, you must log in as Administrator, navigate to C:\Windows\System32, right click the Cmd.exe le, and

select the Run as Administrator option before running the above command.

4 For WES7 devices, prepare the device to pull the image by navigating to the C:\windows\setup folder in the command prompt and

running the following command:

WES7_CustomSysprep4man.bat -r

For WE8S and WIE10 devices, prepare the device to pull the image by navigating to the C:\windows\setup folder in the command

prompt and running the following commands:

Powershell.eexe c:\windows\setup\WIE10_CustomSysprep4man.psl -r

NOTE

: For WE8S devices, you must run the command prompt as an Administrator. See Step 3.

5 Do not allow the device to boot to the OS, instead give the Pull Image command using the PXE mode for WES7 devices, and the

Non PXE mode for the WE8S and WIE10 devices where the sysprep is running.

System