Administrator Guide
Management of Teradici device using WDM
Pre-requisite: Make sure you have already installed a WDM server with ThreadX support for the 5.x rmware.
This section provides the information about the infrastructure changes needed for devices to discover, and register with management
servers including Wyse Device Manager (WDM).
Supported Platforms:
Supports the following Teradici based Dell WYSE devices:
• Wyse 5030 zero client for VMware
• Wyse 5050 AIO thin client with PCoIP
• Wyse 7030 zero client for VMware
Firmware versions:
• 4.x
• 5.x
NOTE
: The following instructions are based on windows 2012 R2 DNS. The exact settings may look dierent depending on the
version of windows.
Topics:
• Steps to create a DNS_SRV record
• Monitoring and Troubleshooting
• Conguring rmware 5.x
• Upgrading the ThreadX 4.x devices to ThreadX 5.x from WDM
Steps to create a DNS_SRV record
The rmware 4.x uses either DNS_SRV record or DHCP record to locate its management console.
NOTE
: Do not use DNS_SRV record and DHCP record at the same time to locate rmware 4.x management console.
The instructions described in this section mainly focuses on DNS_SRV record. The DNS record is _tcp_pcoip-tool in the domain that the
client is congured to communicate with, and the congurations are expected to be done on the DNS server.
In the following example the domain name is delldemo.int, and WDM server is dell-wdm55.delldemo.int
1 Navigate to _tcp under your domain, then right click and select Other new records.
9
Management of Teradici device using WDM 71