Install Guide

11. In the Advanced Settings window, select IPv4 and click Properties.
12. Enter the IP address, Subnet mask, Default gateway and the Preferred DNS server. Click OK.
13. Repeat steps 10 and 11 for the Private network.
14. Make sure that the Private network contains only the IP address and Subnet mask. The Default Gateway or DNS Servers
should not be dened.
15. Make sure that the servers can communicate acoss this network so that the nodes can communicate with each other across
the network.
16. Launch the Server Manager from Start → Administrative Tools. Select Features.
17. Click Add Features to launch the Add Features wizard.
18. Select Failover Clustering and click Next.
19. Make sure that the Failover Clustering option appears in the Conrm Installation Selections screen. Click Install. The
installation progress is displayed.
20. After installation completes, check the installation results and click Close.
After the Failover Clustering installation is complete, reboot the server.
GUID-034F12D6-8E93-4756-A713-6A039EA4CC28
Validating a Conguration
After you install Failover Clustering, you must validate the conguration on the primary node. To validate the conguration:
1. Launch the Server Manager of the primary node from Start → Administrative Tools.
2. Select Failover Cluster Manager under Features.
3. Click Validate a Conguration to launch the wizard.
4. Click Next to add the primary and secondary nodes.
5. Enter the hostname of the primary node.
6. Click Add to select the servers. The screen displays the following message while adding the servers: “The operation is taking
longer than expected”. You need to wait for a few minutes for the servers to be added.
7. After the servers are selected, they are displayed under Selected Servers. Click Next.
8. A multi-site cluster does not need to pass the storage validation . To skip the storage validation process click Run only the tests I
select and click Next.
9. In the Test Selection screen, uncheck the Storage option and click Next to continue.
The Conrmation screen is displayed.
10. Click Next to start running the validation tests on the primary and secondary nodes (in this case cluster1 and cluster2). The
status of the validation tests are displayed on the screen.
11. View the validation summary and click Finish.
GUID-A66249CB-34E4-4776-8570-864D13FCB118
Creating a Cluster on the Primary Node
After you install and validate the Failover Cluster Manager feature on the primary node, you can create a cluster.
To create a cluster on the primary node:
1. Launch Server Manager on the primary node, select Failover Cluster Manager under Features, and click Create a Cluster.
2. Click Next on the wizard.
3. Click Next to continue and in the Select Servers screen, enter the hostname of the primary node, and click Add to add the
server
4. Enter the name of the secondary node and click Add.
5. After the servers are added, click Next to continue. You are prompted to validate your cluster. Select No since your cluster is
validated.
6. Select the second option on the screen and click Next to continue.
63