Manualshelf

Administrator Guide

ManualsBrandsDell ManualsConverged InfrastructureWyse Management Suite
131132133134135136137138139140
Table Of Contents
To enable the CA validation option in the private cloud, you must install the same self-signed certificate on the ThinOS
device as well. If you have not installed the self-signed certificate in the ThinOS device then do not select the Enable CA
Validation check box. You can install the certificate to the device by using Wyse Management Suite after registration, and
then enable the CA validation option.
NOTE:
For the public cloud version of Wyse Management Suite in USA data-center, do not change the default WMS server and
MQTT server details. For the public cloud version of Wyse Management Suite in Europe data-center, use the following:
● CCM Server—eu1.wysemanagementsuite.com
● MQTT Server—eu1-pns.wysemanagementsuite.com:1883
7. To verify the setup, click Validate Key. The device automatically restarts after the key is validated.
NOTE: If the key is not validated, verify the group key and WMS server URL which you have provided. Ensure that
ports 443 and 1883 are not blocked by the network.
8. Click OK.
Device is registered on Wyse Management Suite console.
Registering Wyse Software Thin Client to Wyse Management Suite
by using Wyse Device Agent
About this task
Prerequisites
Create a group to register a device to Wyse Management Suite.
Steps
Steps
1. Open the Wyse Device Agent application.
The Wyse Device Agent window is displayed.
2. Enter the device registration details.
3. From the Management Server drop-down list, select Wyse Management Suite.
4. Enter the server address and the port number in the respective fields.
5. Enter the group token. For a single tenant, the group token is an optional step.
6. Click Register.
After the registration is complete, the Registered to Wyse Management Suite message is displayed.
Registering Linux thin clients using Wyse Device Agent
About this task
NOTE:
Creating a group is a pre-requisite for registering the thin client to Wyse Management Suite. For information, see
Add a group.
Steps
1. Open the Wyse Device Agent (WDA) application.
The Wyse Device Agent window is displayed.
2. Enter the device registration details.
3. In the Wyse Management Suite tab, enter the Wyse Management Suite server address.
4. Enter the group token.
5. Click Register.
After the registration is complete, the Registered to Wyse Management Suite message is displayed.
Managing devices
133