Deployment Guide

Custom port configurations

Wyse Management Suite uses the following port as the default port for the applications that are installed:

• Apache Tomcat: 443

• MariaDB database: 3306

• Mongo database: 27017

• MQTT Broker: 1883

• Memcached: 11211

• EMSDK: 5172, 49159—optional and required only to manage Teradici devices

It is recommended that you use the default port for one or more of the preceding services. If you have a port conflict and are unable to

use the default port, Wyse Management Suite enables you to change the default port during installation.

To use a non-default port for one or more of the preceding services, use Custom install option during Wyse Management Suite

installation. The option that is listed in the following screen enables you to use the local database for MongoDB and MariaDB or use the

remotely installed database:

NOTE: You can configure only the Tomcat connection port 49159 for Teradici. You cannot configure the device port

5172.

For more information about the custom installation, see the Custom installation section in Dell Wyse Management Suite 2.x Quick Start

Guide at support.dell.com/manuals.

Topics:

• Change the Tomcat service port

• Change the MQTT port

• Change the MariaDB port

• Change the MongoDB database port

• Remote repository

Change the Tomcat service port

This section explains how to change the port after installing Wyse Management Suite. Reinstall using Custom installation mode to change

ports. If reinstallation is not an option, the following sections explain the procedure to change the ports manually:

To change the Tomcat service port, do the following:

1. Stop the Tomcat service. The Tomcat service is identified by Dell WMS: Tomcat Service entry.

2. Edit the file <INSTALLDIR>\Tomcat-9\conf\server.xml in a text editor.

3. Find and replace all occurrences of port entry 443 with the port number you need to use. It is optional to change the references to

port 8443.

4. Save the server.xml file and exit.

5. Start the Tomcat service.

6. Enter the port number in the URL (default port 443 can be omitted from the URL), For example, https://

xyz.wysemanagementsuite.com:553/ccm-web. The port that is specified in the URL must be used for both portal access and for

device registration.

NOTE:

The Memcached port can be changed during Wyse Management Suite installation. Dell recommends not to

change the Memcached port detail after installation.

Change the MQTT port

1. Stop the Tomcat and MQTT services.

2. Perform the following steps to configure the MQTT broker service:

a) Edit the file <INSTALLDIR>\wmsmqtt\mqtt.conf in a text editor.

Custom port configurations 13