Administrator Guide

4 Enter the Group Registration Key as congured by your administrator for the desired group.
5 Select the Enable WMS Advanced Settings option, and enter the WMS server or MQTT server details.
6 Enable or disable CA validation based on your license type. For public cloud, select the Enable CA Validation check box, and for
private cloud, select the Enable CA Validation check box if you have imported certicates from a well-known certicate authority into
your Wyse Management Suite server.
To enable the CA validation option in the private cloud, you must install the same self-signed certicate on the ThinOS device as well.
If you have not installed the self-signed certicate in the ThinOS device then do not select the Enable CA Validation check box. You
can install the certicate to the device by using Wyse Management Suite after registration, and then enable the CA validation option.
NOTE:
For the public cloud version of Wyse Management Suite in USA data-center, do not change the default WMS server and
MQTT server details. For the public cloud version of Wyse Management Suite in Europe data-center, use the following:
• CCM Server—eu1.wysemanagementsuite.com
• MQTT Server—eu1-pns.wysemanagementsuite.com:1883
7
To verify the setup, click Validate Key. The device automatically restarts after the key is validated.
NOTE: If the key is not validated, verify the group key and WMS server URL which you have provided. Ensure that ports
443 and 1883 are not blocked by the network.
8 Click OK.
Device is registered on Wyse Management Suite console.
Registering Wyse Software Thin Client to Wyse Management
Suite by using Wyse Device Agent
Prerequisites
Create a group to register a device to Wyse Management Suite.
Steps
1 Open the Wyse Device Agent application.
The Wyse Device Agent window is displayed.
2 Enter the device registration details.
3 From the Management Server drop-down list, select Wyse Management Suite.
4 Enter the server address and the port number in the respective elds.
5 Enter the group token. For a single tenant, the group token is an optional step.
6 Click Register.
After the registration is complete, the Registered to Wyse Management Suite message is displayed.
Registering Linux thin clients using Wyse Device Agent
NOTE
: Creating a group is a pre-requisite for registering the thin client to Wyse Management Suite. For information, see Add a
group.
1 Open the Wyse Device Agent (WDA) application.
The Wyse Device Agent window is displayed.
2 Enter the device registration details.
3 In the Wyse Management Suite tab, enter the Wyse Management Suite server address.
4 Enter the group token.
5 Click Register.
After the registration is complete, the Registered to Wyse Management Suite message is displayed.
142
Managing devices