Reference Guide
Table Of Contents
- Dell Wyse Management Suite Version 3.x High Availability Guide
- Contents
- Introduction
- High availability architecture
- High availability on Windows Server 2012 R2/2016/2019
- Achieve high availability on Windows Server 2012 R2/2016/2019
- Achieve high availability for MySQL InnoDB
- Achieve high availability on MongoDB
- Achieve high availability for Teradici devices
- Install Wyse Management Suite on Windows Server 2012 R2/2016/2019
- Post installation checks
- Upgrade Wyse Management Suite version 1.3 to 1.4
- Upgrading from Wyse Management Suite version 1.4/1.4.1/2.x/2.1 to Wyse Management Suite version 3.x
- Troubleshooting
Figure 79. Access point
3. Check the version of the Tomcat service. If the version of the Tomcat service is 8, you must manually remove Tomcat‐
8 and add Tomcat‐9 service into the Access Point. This is because, when you upgrade Wyse Management
Suite 1.4 to WMS 2.0, Tomcat‐8 service is replaced with Tomcat‐9.
4. Right-click the Tomcat-8 service, and then click Remove.
Figure 80. Tomcat service removal
5. Add the Tomcat-9 service to the access point.
80
Upgrade Wyse Management Suite version 1.3 to 1.4